HPE FlexNetwork 5130 EI Series User Manual

281
lldp fast-count
Use lldp fast-count to set the number of LLDP frames sent each time fast LLDP frame
transmission is triggered.
Use undo lldp fast-count to restore the default.
Syntax
lldp fast-count count
undo lldp fast-count
Default
Four LLDP frames are sent each time fast LLDP frame transmission is triggered.
Views
System view
Predefined user roles
network-admin
Parameters
count: Sets the number of LLDP frames sent each time fast LLDP frame transmission is triggered.
The value range is 1 to 8.
Examples
# Configure the device to send five LLDP frames each time fast LLDP frame transmission is
triggered.
<Sysname> system-view
[Sysname] lldp fast-count 5
lldp global enable
Use lldp global enable to enable LLDP globally.
Use
undo lldp global enable to disable LLDP globally.
Syntax
lldp global enable
undo lldp global enable
Default
If the device is started with the software default settings, LLDP is disabled globally.
If the device is started with the factory default settings, LLDP is enabled globally.
For more information about device startup with software or factory default settings, see
Fundamentals Configuration Guide.
Views
System view
Predefined user roles
network-admin
Usage guidelines
LLDP takes effect on a port only when LLDP is enabled both globally and on the port.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English