HPE FlexNetwork 5130 EI Series User Manual

94
[Sysname-Bridge-Aggregation1] lacp select speed
lacp system-priority
Use lacp system-priority to set the system LACP priority.
Use
undo lacp system-priority to restore the default.
Syntax
lacp system-priority priority
undo lacp system-priority
Default
The system LACP priority is 32768.
Views
System view
Predefined user roles
network-admin
Parameters
priority: Specifies the system LACP priority in the range of 0 to 65535. The smaller the value, the
higher the system LACP priority.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64
Related commands
link-aggregation port-priority
link-aggregation bfd ipv4
Use link-aggregation bfd ipv4 to enable BFD for an aggregation group.
Use
undo link-aggregation bfd to disable BFD for an aggregation group.
Syntax
link-aggregation bfd ipv4 source ip-address destination ip-address
undo link-aggregation bfd
Default
BFD is disabled for an aggregation group.
Views
Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
source ip-address: Specifies the unicast source IP address of BFD sessions. The source IP
address cannot be 0.0.0.0.

HPE FlexNetwork 5130 EI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5130 EI Series
Category	Switch
Language	English