311
mirroring-group monitor-egress
Use mirroring-group monitor-egress to configure the egress port for a remote source group.
Use undo mirroring-group monitor-egress to restore the default.
Syntax
In system view:
mirroring-group group-id monitor-egress interface-type interface-number
undo mirroring-group group-id monitor-egress interface-type interface-number
In interface view:
mirroring-group group-id monitor-egress
undo mirroring-group group-id monitor-egress
Default
No egress port is configured for a remote source group.
Views
System view
Interface view
Predefined user roles
network-admin
Parameters
group-id: Specifies a mirroring group by its number. The specified mirroring group must already exist.
The value range for this argument is 1 to 4.
interface-type interface-number: Specifies a port by its type and number.
Usage guidelines
You can configure egress ports only for remote source groups.
For port mirroring to work correctly, disable the following features on the egress port of a mirroring
group:
• Spanning tree.
• 802.1X.
• IGMP snooping.
• Static ARP.
• MAC address learning.
The member port of an existing mirroring group cannot be configured as an egress port.
The member port of an aggregate interface cannot be configured as an egress port.
Examples
# Create remote source group 1. Configure GigabitEthernet 1/0/1 as its egress port in system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 monitor-egress gigabitethernet 1/0/1
# Create remote source group 2. Configure GigabitEthernet 1/0/2 as its egress port in interface view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
To Next Page
Loading...
Need help?
General