HPE FlexNetwork 5130 HI SERIES User Manual

329
Log buffer: Enabled
Max buffer size: 1024
Actual buffer size: 512
Dropped messages: 0
Overwritten messages: 718
Current messages: 512
%Jun 17 15:57:09:578 2016 Sysname SYSLOG/7/SYS_RESTART:System restarted --
…
Table 81 Command output
Field Description
Log buffer
Status of the log buffer:
• Enabled—Logs can be output to the log buffer.
• Disabled—Logs cannot be output to the buffer.
Max buffer size Maximum buffer size supported by the device.
Actual buffer size
Maximum buffer size configured by using the
info-center logbuffer size
command.
Dropped messages Number of dropped messages.
Overwritten messages Number of overwritten messages.
Current messages Number of current messages.
Related commands
info-center logbuffer
reset logbuffer
display logbuffer summary
Use display logbuffer summary to display the summary of the log buffer.
Syntax
display logbuffer summary [ level severity | slot slot-number ] *
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
level severity: Specifies a severity level in the range of 0 to 7. If you do not specify a severity level,
this command displays log information of all levels in the log buffer. For more information about log
levels, see Table 80.
slot slot
-num
ber: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command displays information for all member devices.
Examples
# Display the summary of the log buffer.
<Sysname> display logbuffer summary

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English