55
• For other types of operations, this argument specifies the times of probes to the destination per
operation. The value range for this argument is 1 to 15.
Usage guidelines
The following describes how NQA performs different types of operations:
• A TCP or DLSw operation sets up a connection.
• An ICMP jitter or UDP jitter operation sends a number of probe packets. The number of probe
packets is set by using the probe packet-number command.
• An FTP operation uploads or downloads a file.
• An HTTP operation gets a Web page.
• A DHCP operation gets an IP address through DHCP.
• A DNS operation translates a domain name to an IP address.
• An ICMP echo sends an ICMP echo request.
• A UDP echo operation sends a UDP packet.
• An SNMP operation sends one SNMPv1 packet, one SNMPv2c packet, and one SNMPv3
packet.
• A UDP tracert operation determines the routing path from the source to the destination. The
number of probe packets sent to each hop is set by using the probe count command.
• A frame loss, latency, or throughput operation sends probe frames to the destination device to
test the frame loss ratio, latency, or throughput of the network.
If an operation is to perform multiple probes, the NQA client starts a new probe in one of the following
conditions:
• The NQA client receives responses to packets sent in the last probe.
• The probe timeout time expires.
This command is not available for the voice or path jitter operations. Each of these operations
performs only one probe.
Examples
# Configure the ICMP echo operation to perform 10 probes.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] probe count 10
probe packet-interval
Use probe packet-interval to configure the packet sending interval in the probe.
Use undo probe packet-interval to restore the default.
Syntax
probe packet-interval interval
undo probe packet-interval
Default
The packet sending interval is 20 milliseconds.
Views
ICMP jitter/path jitter/UDP jitter/voice operation view
To Next Page
Loading...
Need help?
General