HPE FlexNetwork 5130 HI SERIES User Manual

51
[Sysname] nqa template icmp icmptplt
[Sysname-nqatplt-icmp-icmptplt]
operation (FTP operation view)
Use operation to specify the operation type for the FTP operation.
Use undo operation to restore the default.
Syntax
operation { get | put }
undo operation
Default
The FTP operation type is get.
Views
FTP operation view
FTP template view
Predefined user roles
network-admin
Parameters
get: Gets a file from the FTP server.
put: Transfers a file to the FTP server.
Usage guidelines
When you perform the put operation with the filename command configured, make sure the file
exists on the NQA client.
If you get a file from the FTP server, make sure the file specified in the URL exists on the FTP server.
The NQA client does not save the file obtained from the FTP server.
Use a small file for the FTP operation. A big file might result in transfer failure because of timeout, or
might affect other services for occupying much network bandwidth.
Examples
# Set the operation type to put for the FTP operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type ftp
[Sysname-nqa-admin-test-ftp] operation put
# In FTP template view, set the operation type to put for the FTP operation.
<Sysname> system-view
[Sysname] nqa template ftp ftptplt
[Sysname-nqatplt-ftp-ftptplt] operation put
Related commands
password
username

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English