HPE FlexNetwork 5130 HI SERIES User Manual

47
undo next-hop ipv6
Default
No next hop IPv6 address is specified for probe packets.
Views
ICMP echo operation view
ICMP/TCP half open template view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies the IPv6 address of the next hop. IPv6 link-local addresses are not
supported.
Usage guidelines
If the next hop IPv6 address is not configured, the device searches the routing table to determine the
next hop IPv6 address for the probe packets.
Examples
# Specify 10::1 as the next hop IPv6 address for the ICMP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] next-hop ipv6 10::1
no-fragment enable
Use no-fragment enable to enable the no-fragmentation feature.
Use undo no-fragment enable to disable the no-fragmentation feature.
Syntax
no-fragment enable
undo no-fragment enable
Default
The no-fragmentation feature is disabled.
Views
UDP tracert operation view
Predefined user roles
network-admin
Usage guidelines
The no-fragmentation feature sets the DF field to 1. Packets with the DF field set cannot be
fragmented during the forwarding process.
You can use this command to test the path MTU of a link.
Examples
# Enable the no-fragmentation feature for the UDP tracert operation.
<Sysname> system-view
[Sysname] nqa entry admin test

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English