10. On the YaST Control Center screen, click Software Management.
11. Select View > Patterns.
12. Scroll down to Foundation.
13. Check the box to the left of Foundation Libraries, Software, and Drivers, and click Accept.
14. On the Changed Packages pop up, click Continue.
15. Insert CDs into the DVD drive as directed by the prompts on the Perform Installation screen.
If necessary, click Eject on the YaST2 pop up to open the DVD drive. In the YaST2 pop up, you
might need to click Retry more than once to read a new disc. You can ignore the graphic
representation of the file system that appears in a new window during this step.
16. Close the YaST session.
17. Open a terminal window on the booted system.
18. In the terminal window, type the following command to reboot the system:
# reboot
19. After the system reaches the EFI shell, in the RMC command window, type the following command
to reset the full system:
# power reset
The MC990 X server installation is finished at this time.
SLES 11 platform installation on an Integrity MC990 X system 41
To Next Page
Loading...
