Additional software features for the Integrity
MC990 X system
Additional software features are used to remote manage, configure security, debug and create crash
dumps for the Integrity MC990 X system.
Remote management through the ipmitool command
From a remote console, you can use ipmitool commands to perform typical system operations.
For the ipmitool command to work, the remote console must be on the same local network as the
Integrity MC990 X system. The following shows the ipmitool command format:
ipmitool -I lanplus -H <hostname> -U ADMIN -P <password> <command>
The arguments to the command parameters are as follows:
Parameter
Meaning
<hostname>
The hostname of the Integrity MC990 X system on your network.
<password>
The system administrative password. The factory-shipped, default password is ADMIN.
<command>
One of the ipmitool commands.
There many IPMI commands. The commands that HPE supports for Integrity MC990 X system
remote management are as follows:
• power off
• power reset
• power on
Security-Enhanced Linux (SELinux) configuration on
RHEL platforms
You can configure SELinux on an Integrity MC990 X system computer that runs the RHEL operating
system. SELinux supports Multi-Level Security (MLS) and Multi-Category Security (MCS) modes. When
you configure SELinux, you create an MLS-compliant or MCS-compliant environment on an Integrity
MC990 X system, and you enable MPI programs to take full advantage of all the features that Accelerate
provides on MC990 X hardware. For more information about SELinux, see your RHEL documentation.
52 Additional software features for the Integrity MC990 X system
To Next Page