Wall or Under-table Mounting: To mount the 1820
24G, 1820 24G PoE+, 1820 24G PoE+, 1820 48G,
and 1820 48G PoE+ switches:
• First attach the mounting brackets to the switch by
using the included 8-mm M4 screws with a #1
Phillips (cross-head) screwdriver.
• Then attach the switch to the wall or wood surface
with two 5/8-inch number 12 wood screws (not
included).
To mount the 1820 8G and 1820 8G PoE+ switches:
• First, mark the position for the mounting screws.
The hole-to-hole distance is 3.54 inch (90-mm).
• Then, use a #1 Phillips (cross-head) screwdriver
and two of the included 20-mm 4 tap screws. Set
the screw heads approximately 2 mm away from
the mounting surface to allow the switch to slide
on to the screws. Wall anchors are included in the
accessory kit for use with plastered brick or
concrete walls.
• For an under-table mounting, a third 20-mm M4
tap screw can be placed against one side of the
switch to secure it in place.
IMPORTANT:
Wall-mount the switch with network ports
facing up or down (away from or toward the
floor). Do not wall-mount the switch with the
ventilation holes facing up or down. (See
Installation Precautions.)
5. Power on the switch.
Follow the same procedures as in step 3.
6. Configure the switch for operation on your network (minimal configuration).
6 HPE OfficeConnect 1820 Switch Series
To Next Page
Loading...
