HPE OfficeConnect 1950 12XGT 4SFP+

Questions and Answers:

D
Dennis PayneJul 28, 2025
What to do if the system status LED is off with concurrent RPS and AC inputs on my HPE Switch?
- M
  Morgan DunnJul 28, 2025
  If the system status LED is off when using both RPS and AC inputs on your HPE Switch, first ensure the AC power cord is properly connected to the switch, the AC-input power receptacle, and the AC power outlet. Next, check that the external AC power system and the RPS are functioning correctly and that the switch is securely connected to the RPS. Finally, confirm that the switch's operating temperature is within an acceptable range and that the power module has adequate ventilation. Overheating can cause the power module to shut down as a protective measure.
J
Jack HaleyAug 4, 2025
How to troubleshoot AC input when the system status LED is off on my HPE OfficeConnect 1950 12XGT 4SFP+?
- D
  Dustin TuckerAug 4, 2025
  If the system status LED is off for AC input on your HPE Switch, verify that the AC power cord is securely connected to the switch, the AC-input power receptacle, and the AC power outlet are all in good working order. Also, check that the external AC power system is functioning correctly. Finally, make sure the switch's operating temperature is within the acceptable range and that the power module has adequate ventilation, as overheating can cause the power module to stop working.
G
georgecurryAug 11, 2025
How to fix a garbled display on HPE OfficeConnect 1950 12XGT 4SFP+ configuration terminal?
- T
  Tiffany SmithAug 11, 2025
  To resolve a garbled display on the configuration terminal of your HPE Switch, ensure your terminal settings are configured as follows: Baud rate—38400, Data bits—8, Parity—None, Stop bits—1, Flow control—None.
J
Jordan LaneAug 19, 2025
What to do if there is no display on the configuration terminal of my HPE OfficeConnect 1950 12XGT 4SFP+?
- A
  Andrea KirbyAug 19, 2025
  If there is no display on the configuration terminal of your HPE Switch, verify that the power module is supplying power to the switch and that the console cable is correctly connected. Additionally, ensure the console cable is not faulty and that your PC settings are correct.

HPE OfficeConnect 1950 12XGT 4SFP+ Specifications

General

Switching Capacity	240 Gbps
Forwarding Rate	178.5 Mpps
Layer	Layer 3
Weight	3.7 kg
Operating Temperature	0°C to 45°C
MAC Address Table Size	32768 entries
Power over Ethernet (PoE)	No
Power Supply	100-240 VAC
Jumbo Frame Support	Yes
Routing Protocol	RIP
Features	IPv6 support
Compliant Standards	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1p, IEEE 802.1w, IEEE 802.3ad, IEEE 802.3x, IEEE 802.3ae
Dimensions (W x D x H)	17.42 x 11.18 x 1.73 in
Operating Humidity	10 to 90% non-condensing