4
Installing the switch
Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open
the chassis, contact Hewlett Packard Enterprise for permission. Otherwise, Hewlett Packard
Enterprise shall not be liable for any consequence.
Figure 1 Hardware installation flow
Installing the switch in a 19-inch rack
Use the front mounting brackets to install the switch in a rack.
Start
Install the switch
Ground the switch
Connect power cords
Verify the installation
Power on the switch
Operating correctly?
Power off the
switch
Troubleshoot
the switch
Yes
No
End
Install transceiver modules
and cables
To Next Page
Loading...
