To Next PageTo Next Page
Need help?Do you have a question about the HPE StoreEver 1/8 G2 and is the answer not in the manual?
General| Form Factor | 1U Rack-mountable |
|---|---|
| Drive Technology | LTO Ultrium |
| Number of Slots | 8 |
| Interface | SAS |
| Maximum Capacity | 240 TB |
| Encryption | AES 256-bit |
| Product Type | Tape Autoloader |
| Maximum Native Capacity | 120 TB |
| Maximum Compressed Capacity | 240 TB |
| Supported Media | LTO Ultrium 8, LTO Ultrium 7 |
| Non-operating Temperature | -30°C to 60°C |
| Operating Humidity | 20% to 80% non-condensing |
| Management | Web-based remote management |
| Operating Temperature | 10°C to 35°C |
| Non-operating Humidity | 10% to 95% RH |
Details the components and indicators on the autoloader's front panel.
Describes the various ports and connectors found on the autoloader's rear.
Shows the rear panel configurations for different Fibre Channel and SAS tape drives.
Explains the Operator Control Panel (OCP) and Remote Management Interface (RMI) for autoloader interaction.
Specifies suitable locations for installing the autoloader in a rack or on a shelf.
Details requirements and considerations for Fibre Channel connectivity.
Outlines the necessary hardware and precautions for SAS connectivity.
Prepares the host system, including HBA installation and software setup.
Step-by-step guide for safely unpacking the autoloader and its components.
Instructions for attaching the support feet if the autoloader is not rack-mounted.
Explains how to remove the shipping lock to enable robotic operation.
Guides the installation of the autoloader into various types of server racks.
Instructions for inserting the tape drive into the autoloader bay.
Details how to connect the Fibre Channel cable to the autoloader and host.
Provides instructions for connecting the SAS cable to the autoloader and host.
Steps to safely power on the autoloader and connected host systems.
Guides network configuration for RMI access via DHCP or static IP.
How to find the autoloader's IP address assigned by DHCP.
Steps to configure static IPv4 network settings using the Operator Control Panel.
Instructions for setting the autoloader's date, time, and NTP server.
Process for setting a secure administrator password for OCP and RMI access.
Settings for Fibre Channel interface configuration for SAN or direct host connections.
Recommendations for applying barcode labels to tape cartridges for better inventory.
Step-by-step guide for loading tape cartridges into the autoloader magazines.
Steps to confirm successful communication between the autoloader and the host.
How to check the installed firmware revision and update if necessary.
Instructions on how to download the latest firmware from the HPE support website.
Information on how to find and access official product documentation.
Instructions for providing feedback to improve the documentation.
A list of relevant HPE websites for compatibility, support, and products.
