IMPORTANT:
Access to some updates might require product entitlement when accessed through the Hewlett
Packard Enterprise Support Center. You must have an HPE Passport set up with relevant
entitlements.
To view and update your entitlements, and to link your contracts and warranties with your profile,
navigate to: http://www.hpe.com/support/AccessToSupportMaterials
2. Browse or search for the necessary firmware.
3. Download the firmware.
To upgrade firmware from the OCP, copy the firmware image onto a FAT-32 formatted USB flash drive.
Configuring additional features
The autoloader has many features to customize it for your organization. For more information and
instructions, see the user and service guide.
Procedure
• Naming the autoloader
• Configuring IPv6 networking
• Enabling and configuring SNMP network management
• Setting up network time synchronization with NTP
• Configuring the CommandView TL management station for TapeAssure
• Setting up email event notification.
• Configuring failover (LTO-5 and LTO-6 FC only)
• Configuring use of encryption.
The MSL Encryption Kit provides secure, redundant storage of encryption keys for LTO-4 and later
generation tape drives. If you are using the Encryption Kit with this autoloader, follow the instructions in the
kit to install and configure the Encryption Kit. The Encryption Kit is ordered separately. For information
about the kit, see: http://www.hpe.com/storage/tape.
Configuring additional features 21
To Next Page
Loading...