NOTE:
The autoloader is shipped without an administrator password. You must set the administrator password
with the OCP before you can use the RMI administrator functions. Once the administrator password is
set, you can access the RMI by providing the administrator password on the login screen.
If you enabled IPv6, you must continue configuring IPv6 from the RMI after setting the administrator
password. You can find the IPv6 IP address obtained by the autoloader from the OCP Information/Status >
Network Information menu item. For additional information on configuring IPv6, see the user and service
guide.
Finding the IPv4 IP address obtained through DHCP
Procedure
1. From the Home screen, press Next until the display shows Status/Information. Press Enter.
2. Press Next until the display shows Network Information. Press Enter.
3. The display shows IPv4 Network Enabled. Press Enter.
4. Press Next until the display shows the IP address.
5. Press Cancel until the display shows the home screen.
Configuring IPv4 networking from the OCP
If IPv4 networking is enabled, you can continue configuring the IPv4 network settings from the OCP.
Procedure
1. From the Home screen, press Next until the display shows Configuration. Press Enter.
2. Press Next until the display shows Configure Network Settings. Press Enter.
3. Enter the administrator password, if requested.
4. Press Next until the display shows IPv4 Networking. Press Enter.
5. Press Next until the display shows DHCP (IPv4) Enabled. To change the setting, press Enter. Press
Next until the screen displays the desired setting. Press Enter to accept the new setting.
6. If DHCPv4 is disabled, press Next to display the IP address. To change the IP address, press Enter.
Set the new IP address with the Next, Prev, and Enter keys.
7. Press Next to display the subnet mask. To change the subnet mask, press Enter. Set the new subnet
mask with the Next, Prev, and Enter keys.
8. Press Next to display the gateway address. To change the gateway address, press Enter. Set the new
subnet address with the Next, Prev, and Enter keys.
Setting the date and time
The autoloader uses the date and time to record events and should be set during the initial installation
process. You can also set the date and time or configure an NTP (Network Time Protocol) server from the
RMI Configure > Date/Time screen.
NOTE:
• When setting the hours, the time is based on a 24-hour clock. There is no a.m. or p.m. designation.
For example, 1:00 p.m. is 13:00.
• The autoloader time does not automatically adjust for daylight saving time; you must adjust the time
manually through the OCP or RMI.
• Daylight saving settings are also available through the RMI interface when using SNTP.
Finding the IPv4 IP address obtained through DHCP 17
To Next Page
Loading...