Installing the autoloader
IMPORTANT:
The shipping lock must be removed for the robotics to operate properly. A robot move error is
displayed if the shipping lock is not removed. See Removing the shipping lock on page 12.
WARNING:
The autoloader weighs up to 11.5 kg (25.4 lb) without media and 13.1 kg (28.9 lb) with media (8
cartridges).
When moving the autoloader, to reduce the risk of personal injury or damage to the autoloader:
• Observe local health and safety requirements and guidelines for manual material handling.
• Remove all tape cartridges to reduce the overall weight of the autoloader and to prevent cartridges
from falling into the robotic path and damaging the autoloader. Keep the cartridges organized so they
can be returned to the same locations.
• Obtain adequate assistance to lift and stabilize the autoloader during installation or removal.
WARNING:
When placing the autoloader into a rack, to reduce the risk of personal injury or damage to equipment:
• Extend the rack leveling jacks to the floor.
• Ensure that the full weight of the rack rests on the leveling jacks.
• Install the rack stabilizer kit on the rack.
• Extend only one rack component at a time. Racks can become unstable if more than one component
is extended.
Preparing the host
IMPORTANT:
Use proper procedures to prevent electrostatic discharge (ESD). Use wrist-grounding straps and anti-
static mats when handling internal components.
Procedure
• If you are not the system administrator of the host computer, check with the system administrator before
powering off the computer.
• For an FC autoloader, install an FC HBA or verify that you have sufficient ports available on a compatible
FC switch. See FC connection information on page 8.
• For a SAS autoloader, if necessary, install a SAS HBA with an external SAS connector that supports
multiple LUNs. Refer to the host computer and HBA documentation for installation information. See SAS
connection information on page 9.
• Install application software and compatible drivers on the host computer. See the application software
manuals for installation and configuration information.
• Install the Library & Tape Tools (L&TT) diagnostic utility to see what devices are connected to the host,
verify the installation, upgrade firmware, and aid in troubleshooting.
Download L&TT without charge from: http://www.hpe.com/support/TapeTools
10 Installing the autoloader
To Next Page
Loading...