Why does my HPtec SD4030B3 motor get so hot when it's running?
If your HPtec Control Unit motor's temperature rises abnormally high during rotation, it's likely because the RUN potentiometer setting is too high for the motor's rated current. To resolve this, reduce the RUN potentiometer setting.
What to do if my HPtec Control Unit motor gets too hot when stopped?
If your HPtec Control Unit motor's temperature becomes abnormally high when it is stopped, the Auto Current Down feature may be disabled. To fix this, turn on SW1-4.
Why isn't my HPtec SD4030B3 Control Unit motor turning on?
If the motor of your HPtec Control Unit isn't turning, it could be due to the command pulse not being input. Check the host controller side to ensure the command pulse is correctly sent.
What to do if HPtec SD4030B3 motor doesn't change direction?
If your HPtec Control Unit motor does not invert its rotation direction even when switching the CW/CCW pulse input, short 3-5, 4-6 of jumper JP 1.
How to turn off JOG mode on HPtec SD4030B3?
To turn off JOG mode on your HPtec Control Unit, turn off 5 and 6 of DIP switch SW1.
Highlights essential precautions for safe and appropriate product operation.
Key safety guidelines regarding electrical hazards, burns, and property damage.
Essential operational restrictions and required safety actions for proper use.
Guidelines for physical installation, air convection, and electrical connector wiring.
Pin assignments and definitions for the CN1 connector.
Procedure for setting the peak current value using the RUN potentiometer.
General| Brand | HPtec |
|---|---|
| Model | SD4030B3 |
| Category | Control Unit |
| Language | English |
To Next Page