HT MULTITEST M72 User Manual

MULTITEST M72 - M73 - M74 - M75
EN - 10
8.
DC voltage value
Example of display of DC voltage. The
minimum reading limit of DC voltage is
1.2V. Lower input values are displayed
as 0.0V.
9.
MODE
PEAK
Press MODE PEAK for less than 1 second to pass to frequency
measurement (only during AC measurements, see paragraph 4.3.1)
10.
MODE
PEAK
Press MODE PEAK for more than 1 second to detect the voltage peak value
(see paragraph 4.2.3)
11.
FUNC
HOLD
Press FUNC HOLD for less than 1 second to block the detected values on the
display (see paragraph 4.2.1)
12.
FUNC
HOLD
Press FUNC HOLD for more than 1 second to detect maximum, minimum
and average voltage values (see paragraph 4.2.2)
4.3.1. Frequency measurement
1. In order to detect minimum, average, maximum and peak values of frequency it's
necessary to pass to this measuring parameter.
2.
MODE
PEAK
During AC measurements it’s possible to pass to frequency measurement by
pressing MODE PEAK for less than 1 second
3.
Frequency value
Example of display of frequency value.
The minimum reading limit of frequency
is 30.0Hz. Lower input values are
displayed as <30.0Hz
4.
MODE
PEAK
To resume voltage measurement press MODE PEAK for less than 1 second
5.
MODE
PEAK
To detect the frequency peak value press MODE PEAK for more than 1
second (see paragraph 4.2.3)
6.
FUNC
HOLD
To block the detected frequency value on the display press FUNC HOLD for
less than 1 second (see paragraph 4.2.1)
7.
FUNC
HOLD
To detect maximum, minimum and average frequency values press FUNC
HOLD for more than 1 second (see paragraph 4.2.2)

HT MULTITEST M72 Specifications

General

Brand	HT
Model	MULTITEST M72
Category	Multimeter
Language	English