HTD Lync Series - Using the LyncTouch Controls

23
Using the LyncTouch
LyncTouch is primarily used to control the zone to which it is connected. A handful
of simple commands can also be applied across all zones at once, including
power all off and party mode.
The user interface consists of:
• a 3.5” diagonal color touchscreen display
• 3 tactile buttons:
Power Button
Quick Key (Favorite) Button
Talk Button
• 2 microphones (only active while the Talk Button is pressed)
Power Button
As its name implies, the Power Button is primarily used to turn a zone on
and off, but it can also be used to quickly mute the volume within the zone
and power off all zones.
Power On – when a zone is OFF, a quick press of the Power Button will turn it
ON
Mute – when a zone is ON, a quick press of the Power Button will mute the volume in the zone. Press the Power
Button again to un-mute.
Power Off – when a zone is ON, it can be powered OFF by pressing the Power Button for approximately 1
second. Once turned off, LyncTouch will display “OFF”. Release the Power Button.
Power Off All Zones – when a zone is ON, press and hold the Power Button for approximately 3 seconds. The
display will rst display “OFF” followed by “ALL ZONES OFF”. Release the Power Button.
Quick Key
The Quick Key is a button you can customize to allow a single button press to turn on the zone and then
activate up to two separate ACTIONS. The most common use of the Quick Key is to turn on a zone and
set it to your favorite source [ACTION 1] at your favorite volume [ACTION 2]. Alternative actions include Power
Off, All Zones Off, DND (Do Not Disturb) On, and DND Off.
Talk Button
Press and hold the talk button to talk into any single zone OR all zones that are currently powered on. Read
more under the heading: Using the Intercom.
DND – Do Not Disturb. When selected, global commands such as ALL OFF, Intercom ALL, and Party Mode will
be ignored.
Intercom – Touch this area to select a zone in which to intercom. Read more under the heading, “Using the
Intercom”
Party – Party Mode. When selected, all zones not currently in DND will be powered on and set to the source
currently selected for this zone. Prior to executing this command, a message will rst appear requiring conrmation
of this action.
Source Name/Change Source – Touch this area to select a source from a list of all available sources.
Volume Bar – Control volume dynamically by sliding your nger along the slider bar or by pressing and holding
the volume up or volume down icons. Incrementally adjust volume by tapping on the volume up or volume down
icons.