HTD Lync Series - Quick Key and Firmware Update

25
Using the LyncTouch
Customize the favorite (heart) button. Actions assigned here will be executed with a single
press of the Quick Key button.
Action 1 – press the rst pair of “minus” and “plus” buttons to toggle between
your options for the rst action. When “Source” is selected, use the second
pair of “minus” and “plus” buttons to select from your available sources; when
“Volume” is selected, use the second pair of “minus” and “plus” buttons to set
a volume level between 1 and 60 (max).
Action 2 – As long as an action other than “None” has been assigned to Action
1, Action 2 will also be executed when pressing the Quick Key. The same
options found in Action 1 are available for Action 2.
Occasionally, HTD may elect to provide an update to the rmware on the LyncTouch. Use this
screen to temporarily connect to your own private WiFi network with internet access in order
to check for the availability of new rmware and to update the rmware when available. The
LyncTouch will only maintain connection to your WiFi network when you turn WiFi on and continue to stay on this
screen. Once you exit this screen, the LyncTouch will automatically disconnect from your network.
Updating the Firmware (we have a video on our website and YouTube
for this)
Step 1. Press “Wi: Off” to activate the WiFi chip embedded in LyncTouch. The
screen will display “WiFi: Started . . .”. If you have previously connected the
LyncTouch to your WiFi network, then “Wi: Connected” should appear and
you can skip to Step 4. If instead, you see “WiFi: AP Mode”, proceed to Step 2.
Step 2. AP Mode. In this mode, LyncTouch is broadcasting its own WiFi network
and is ready to be connected to your existing private network. Open a mobile
device near the LyncTouch and look for a WiFi network called “LyncTouch-X”
where “X” represents the zone number in which the LyncTouch is attached.
Connect to that network. A page should automatically appear on your mobile
device titled, “LyncTouch WiFi Setup Wizard”. [note: if this page does not
automatically appear, type 192.168.4.1 into the address bar of your browser]
Step 3. Press SCAN and select your private network. Enter and save the
password for this network. At this point, LyncTouch will display “WiFi: Starting .
. .” and your mobile device will be disconnected from the LyncTouch-X network.
If successful, the display will change to “WiFi: Connected” and you can proceed to Step 4. If the LyncTouch
returns to “WiFi: AP Mode”, then the LyncTouch did not successfully attach to your network. Return to Step 2 and
try again, paying close attention to the password entered.
Back
Source
Patio TV
Quick Key Settings
Update Settings
Quick Key
Update