24
Enclose: Explanation of the Error Codes
In the process of using, the display of the fire, wind and other patterns disappeared, because the
security device has been caused by action. Display flashing fault code shows that the failure of its
occurrence, the reason for the exception.
Fault code has been flashing when failure. On such occasions, please turn off the hot water value
and then open,or close / open the monitor, and then operate 1-2 times. If the display still show
the fault code, please be sure to close the water valve and valve, unplug the power plug, and
contact the after-sales service.
Error Code Explanation
01 Inlet water temperature sensor breaks down
10 Detect a flame signal through pre-check
11 Ignition fails
12 Normal combustion flames out accidentally
13 Thermostat fault protection
32 Fan blocking protection
40 Fan or its drive circuit breaks down
50
Over high temperature protection（outlet）
51
Over high temperature protection（inlet）
60 Outlet water temperature sensor fault protection
80
Timing protection
Packaging and Accessories
Description Quantity
Gas water heater 1 pc
Connector of gas inlet (with rubber seal ring) 1 pc
Expansion screws 1 set
Mounting screws 2 pcs
User manual 1 pc
Self-tapping screws 2 pcs
Flue duct（B23 type）
1 set
To Next Page
Loading...
Need help?
General
