Muting an incoming call
Open the watch's app list, go to Settings > Accessibility features > Gestures, and enable
Mute incoming calls gesture.
After this feature is enabled, with the screen facing up and your palm facing down, quickly
rotate your wrist outwards by 90 degrees and rotate back to mute an incoming call.
Measuring your body temperature
Body temperature measurements are mainly used to monitor the changes in the wrist skin
temperature during and after exercise. After you enable a continuous skin temperature
measurement, your skin temperature will be continuously measured and a measurement
curve will be generated.
• The product is not a certied medical device. Body temperature measurements are
mainly used to monitor the changes in the wrist skin temperature of healthy people
over the age of 18 during and after exercise. Results are for reference only and should
not be used as a basis for medical diagnosis or treatment.
• During the measurement, wear the device relatively tightly for more than 10 minutes
and stay in a relaxed environment at room temperature (about 25°C). Ensure that
there are no water stains or alcohol on your wrist. Do not start a measurement in an
environment with direct sunlight, wind, or cold/heat sources.
• After you exercise, shower, or switch between outdoor and indoor environments, wait
30 minutes before you start a measurement.
Single measurement
In the watch's app list, go to Skin temperature > Measure to start measuring your
temperature.
Continuous measurement
1 Open the Heath app, touch Devices and then the device name, go to Health monitoring,
and enable Continuous skin temperature measurement.
2 In the watch's app list, touch Skin temperature to view the measurement curve.
Getting started
6
To Next Page
Loading...
Need help?
General
