Huawei AR1200 Series - Checking the Configuration; Maintaining the WLAN Service; Resetting an AP

Prerequisite
l A radio profile has been bound to the specified radio according to 1.3.4 Binding a Radio
Profile to a Radio
l A service set has been configured according to 1.4.5 Configuring a WLAN Service Set.
Context
A VAP is a functional entity on an AP. You can create a VAP on a radio interface by binding a
service set to the radio interface.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface wlan-radio 0/0/0
The radio view is displayed.
Step 3 Run:
service-set { name service-set-name | id service-set-id } [ wlan wlan-id ]
A service set is bound to the radio.
----End
1.4.7 Checking the Configuration
After configuring the WLAN service, use the following commands to verify the configuration.
Procedure
Step 1 Run the display vap command to view the VAP configuration.
Step 2 Run the display security-profile { all | { id profile-id | name profile-name } [ detail ] } command
to view information about security profiles.
Step 3 Run the display traffic-profile { all | id profile-id | name profile-name } command to view
information about traffic profiles.
Step 4 Run the display service-set { all | id service-set-id | name service-set-name | ssid ssid }
command to view information about service sets.
----End
1.5 Maintaining the WLAN Service
This section describes how to reset APs.
1.5.1 Resetting an AP
Reset an AP when it cannot work properly.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - WLAN 1 WLAN Configuration
Issue 03 (2012-01-06) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19