Table 3-79 LTE antenna interface attributes
Attribute Description
Connector type SMA-K (screw threads outside and a hole inside)
Standards
compliance and
frequency bands
supported
l LTE FDD: bands 1/2/3/4/5/7/8/20
l DC-HSPA+/HSPA+/HSPA/WCDMA: bands 1/2/5/8
l GSM/GPRS/EDGE: 850/900/1800/1900 (MHz)
Rate
l General Packet Radio Service (GPRS): uplink rate of 85.6 kbit/s
and downlink rate of 85.6 kbit/s
l Enhanced Data Rates for GSM Evolution (EDGE): uplink rate of
236.8 kbit/s and downlink rate of 236.8 kbit/s
l Wideband Code Division Multiple Access circuit switched
(WCDMA CS): uplink rate of 64 kbit/s and downlink rate of 64
kbit/s
l WCDMA packet switched (PS): uplink rate of 384 kbit/s and
downlink rate of 384 kbit/s
l High Speed Packet Access Plus (HSPA+): uplink rate of 5.76
Mbit/s and downlink rate of 21.6 Mbit/s
l DC-HSPA+: uplink rate of 5.76 Mbit/s and downlink rate of 43.2
Mbit/s
l Frequency Division Duplexing (FDD) LTE: uplink rate of 50
Mbit/s and downlink rate of 150 Mbit/s
Cable type
l 6.3.2 LTE Whip Antenna
l 6.3.4 Outdoor LTE Antenna
l 6.3.3 LTE Indoor Remote Antenna
DI/DO interface
A DI interface receives alarm input (9.6-60 V), and a DO interface sends output signals to
instruct an external device to perform required actions. Table 3-80 lists DI/DO interface
attributes.
Table 3-80 DI/DO interface attributes
Attribute
Description
Connector type 5-pin Phoenix terminal block
Signal type
l DI: 9.6-60 V DC power input
l DO: Boolean value (short circuit and
open circuit)
RS485/RS422 interface
Huawei
AR500&AR510&AR531&AR550&1500&AR2500
Industrial Switch Routers
Hardware Description
3 Chassis
Issue 10 (2019-03-06) Copyright © Huawei Technologies Co., Ltd. 164
To Next Page
Loading...
