Interface Description
Console Interface
The console interface can connect to an operation terminal for onsite configuration. Table
3-344 lists console interface attributes.
Table 3-344 Console interface attributes
Attribute
Description
Connector type RJ45
Standards compliance RS232
Working mode Full-duplex Universal Asynchronous
Receiver/Transmitter (UART)
Data equipment type Data circuit-terminating equipment (DCE)
Cable type 6.18 Console Cable
FE Combo Interface
An FE combo interface consists of an optical Ethernet interface and an electrical Ethernet
interface on the panel. The two interfaces have only one internal forwarding interface. The
electrical and optical interfaces are multiplexed, and only one of them can work at a time.
When one of the Ethernet interfaces is working, the other interface is shut down.
l The FE electrical interface (10/100 Mbit/s auto-sensing) transmits and receives services
at 10 Mbit/s or 100 Mbit/s.
l The FE optical interface (100 Mbit/s) transmits and receives services at 100 Mbit/s.
NOTE
l In V200R008C30 and earlier versions, a combo interface works as an electrical interface and uses a
network cable to transmit and receive data by default.
l In V200R008C50 and later versions, a combo interface works in auto mode and automatically works
as an optical or electrical interface by default.
GE Optical Interface
A GE optical interface transmits and receives Ethernet services at 1000 Mbit/s. Table 3-345
lists GE optical interface attributes.
Table 3-345 GE optical interface attributes
Attribute
Description
Connector type SFP
Standards compliance IEEE802.3z
Rate 1000 Mbit/s
Huawei
AR500&AR510&AR531&AR550&1500&AR2500
Industrial Switch Routers
Hardware Description
3 Chassis
Issue 10 (2019-03-06) Copyright © Huawei Technologies Co., Ltd. 448
To Next Page
Loading...
