LTE/GPS Extension Cable
NOTE
l A GPS+LTE remote diversity antenna (square shape) is 3 m long by default. If the default length is
not enough for antenna connection, use a LTE/GPS extension cable to prolong the antenna.
l If GPS+LTE remote diversity antennas (square shape) need to be prolonged, configure two
LTE/GPS extension cables for each GPS+LTE remote diversity antenna.
Figure 6-42 shows the connection of LTE/GPS extension cables.
l The SMA male connector of one extension cable is connected to the GPS interface of a
router, and the female connector is connected to SMA male connector of the GPS
antenna.
l The SMA male connector of the other extension cable is connected to the LTE DIV
interface of the router, and the female connector is connected to SMA male connector of
the LTE antenna.
Figure 6-42 Connection of LTE/GPS extension cables
GPS
LTE
Cover
SMA, male
SMA, male
SMA, male
female
LTE/GPS extension cable
SMA, male
female
LTE/GPS extension cable
Technical Specifications
None
Connection
The GPS+LTE remote diversity antenna (square shape) is connected as follows:
l The SMA male connectors at one end of the antenna are connected to the GPS and LTE
DIV interfaces of a router respectively.
l The other end (cover) of the antenna is attached to a plastic horizontal plane.
Ordering Information
Table 6-71 provides the GPS+LTE remote diversity antenna (square shape) ordering
information.
Huawei
AR500&AR510&AR531&AR550&1500&AR2500
Industrial Switch Routers
Hardware Description
6 Cables
Issue 10 (2019-03-06) Copyright © Huawei Technologies Co., Ltd. 696
To Next Page
Loading...
