24
Check and record the following data on the device: SSID,
Encryption type, and key.
Compare the recorded data, the SSID on the network
adapter should be ANY or be the same as that on the
device. The WEP type and key on the network adapter
and device should be the same. Otherwise, you need to
change the data on the network adapter.
What to do if bridging between two devices is
unsuccessful?
Make sure that the two devices work on the same
channel. For details, see "Selecting a WLAN Channel".
Make sure that the MAC address of one device is in the
peer MAC address list of the other device. For details,
see "WDS".
When the signal strength is normal, what to do if
the downloading rate is low?
In this case, you need to set the value in the registry as
follows:
Choose Start > Run.
Enter regedit in the Open text box and then click OK.
Select parameters in the following directory:
\HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlS
et\Services\Tcpip.
Choose Edit > New > DWORD Value.
Rename New Value #1 to TcpWindowSize.
Right-click TcpWindowSize and then select Modify.
Select Decimal and enter 65535 in the Value data text
box, and then click OK.
For the DWORD Value of DefaultRcvWindow, do the
same operations as that of TcpWindowSize.
To Next Page
Loading...
