Huawei ESS-240V12-9AhBPVBA04 - 4.5 Battery Maintenance

CA UTION
Wear protective gloves when removing and installing the support base
components to prevent injury.
Step 3 Install two support bases for each group of battery packs as follows: Place support
bases on the
oor, ensure that the distance between the two support bases is at
least 280 mm, and then place battery packs on the support bases in sequence.
Step 4 After the installation is complete, seal the four screw holes on the top with rubber
plugs that are delivered with the battery packs.
Figure 4-13 Installing battery packs
----End
4.4 Cable Connection
4.4.1 Connecting Cables to Battery Packs for the UPS2000-G-6
kVA/10 kVA
NO TE
If more than one battery pack is connected to the 6 kVA/10 kVA UPS, connect the battery
packs in parallel and then connect them to the UPS battery input ports.
Connecting Cables to Battery Packs for a Single UPS2000-G-6 kVA/10 kVA
NO TE
The following wiring diagram uses a standard UPS with one battery pack as an example.
ESS-240V12-(9AhBPVBA04, 7AhBPVBA04) Battery
Pack
Quick Guide 4 Installation
Issue 02 (2022-06-30) Copyright © Huawei Digital Power Technologies Co., Ltd. 36