Huawei FusionSolar SmartPVMS - Page 14

NO TE
The screenshots in this section are taken from SmartLogger V300R001C00SPC040.
Procedure
Step 1 Set the IP address of the PC. Ensure that the IP address is in the same subnet as
that of the SmartLogger.
Table 3-2 IP address settings description
Device IP Address Settings Default Value on the
SmartLogger
Example PC Setting
SmartLogger3000
Note
WAN
port
IP address 192.168.0.10 192.168.0.11
Subnet
mask
255.255.255.0 255.255.255.0
Default
gateway
192.168.0.1 192.168.0.1
LAN port IP address 192.168.8.10 192.168.8.11
Subnet
mask
255.255.255.0 255.255.255.0
Default
gateway
192.168.8.1 192.168.8.1
Other SmartLogger
models
IP address 192.168.0.10 192.168.0.11
Subnet mask 255.255.255.0 255.255.255.0
Default gateway 192.168.0.1 192.168.0.1
Note:
● When the IP address of the WAN port is in the 192.168.8.1–192.168.8.255 network, the IP
address of the LAN port is automatically switched to 192.168.3.10 and the default gateway is
set to 192.168.3.1. If your PC is connected to a LAN port, you need to adjust the network
conguration of the PC.
● It is recommended that the PC be connected to the LAN port of the SmartLogger or the GE
port of the SmartModule. When the PC is connected to the GE port of the SmartModule, adjust
the network
conguration of the PC in the same way as when the PC is connected to the LAN
port of the SmartLogger.
Step 2 Enter https://XX.XX.XX.XX (IP address of the SmartLogger) in the address bar of
your browser. When you log in to the WebUI for the
rst time, a security risk
warning is displayed. Click Continue to this website (not recommended).
Step 3 Log in to the WebUI.
FusionSolar Smart PV Solution-Device Replacement
Commissioning Guide 3 Software Download or Platform Login Methods
Issue 01 (2021-04-30) Copyright © Huawei Technologies Co., Ltd. 10