4.2 SmartLogger Settings
The SmartLogger and Smart Dongle cannot be used in the same scenario. Set the
parameters based on the actual situation.
4.2.1 SmartLogger
Setting Parameters on the WebUI
Step 1 Log in to the SmartLogger WebUI as an advanced user, special user, or admin,
and choose Maintenance > Connect Device.
Step 2 Select the replaced SUN2000 and remove it.
Figure 4-4 Removing the SUN2000
Step 3 Connect the new SUN2000 to the system.
FusionSolar Smart PV Solution-Device Replacement
Commissioning Guide 4 Replacing the SUN2000
Issue 01 (2021-04-30) Copyright © Huawei Technologies Co., Ltd. 20
To Next Page
Loading...
