Projection
Wi-Fi P2P Projection
Based on the Wi-Fi Direct protocol, devices can use the
IdeaShare client to implement peer-to-peer connections as
long as Wi-Fi is enabled.
Method
Note
• This function applies only to endpoints that support the
Wi-Fi function.
• Android and HarmonyOS phones cannot use
mobile hotspot and Wi-Fi P2P at the same time.
You need to disable mobile hotspot first.
• The following operating system requirements must be
met: Windows 10.0.10240.0 or later, Android 8.0 or
later, and HarmonyOS 2.0 or later.
This method applies only to Android, HarmonyOS, and Windows,
and the IdeaShare version must be V6.19.0.32 or later.
1. Download and install the IdeaShare client on your mobile
phone or computer.
2. Enable Wi-Fi and Wi-Fi Direct on the large screen, and
turn on Wi-Fi on your phone.
3. Enter the large screen projection code on the mobile
phone or computer client. Autocomplete is supported so
you simply need to tap the correct one code from the list
to connect to the large screen. For the first connection,
you need to confirm the connection on the large screen.
4. On the client, click Share Screen to start screen
projection.
To Next Page
Loading...
