IdeaShare Key Projection
Screen Projection
1. Insert the IdeaShare Key into the large screen, wait until
Pairing successful message is displayed, and then
remove the IdeaShare Key.
2. Insert the IdeaShare Key into the computer.
3. After the blue indicator of the IdeaShare Key (Type-A) is
steady on in low brightness or the white indicator of the
IdeaShare Key (Type-C) is steady on, press the
IdeaShare Key button to start projection. Then, you can
press it again to stop projection.
You can use the IdeaShare Key to project from computer
without downloading any projection software.
Method
Note
• IdeaShare Key (Type-A): If you use it for the first time,
you need to install the IdeaShare Key software to
connect the large screen.
• IdeaShare Key (Type-C):
If the Type-C port on the computer supports audio
and video transmission, you can directly connect
the computer to the large screen without installing
the IdeaShare Key software. In addition, no dialog
box will be displayed in the lower right corner of the
computer.
If the Type-C port on the computer does not
support audio and video transmission, the
computer can be connected to a large screen only
when the IdeaShare Key software is installed.
• To install the IdeaShare Key software, perform the
following steps:
Windows: On the home screen after you click My
PC or This PC, double-click the drive or double-
click IdeaShare Key.exe in the drive path to
manually complete the installation.
macOS: Double-click IdeaShareKeySetup in the
IdeaShareKey drive path on the desktop to
manually complete the installation and
authorization.
To Next Page
Loading...
