Use OPS
The Open Pluggable Specification (OPS) is an optional
hardware for the large screen. The OPS has a built-in Windows
10 Enterprise operating system and can be automatically
activated after being powered on and connected to a network.
• Using the built-in microphone:
In the Windows mode, swipe right from the left edge of
the large screen to display the shortcut operation page,
choose Advanced > Camera & Microphone Settings,
and select OPS first.
• Using the software keyboard: In Windows, choose
Setting > Devices > Typing > Touch keyboard and
enable Show the touch keyboard when not in tablet
mode and there's no keyboard attached toggle.
• Security settings: Choose Settings > Advanced >
Advanced Settings Password in the lower right corner
of the home page and set a password, which is
required for accessing advanced settings in
HarmonyOS or Windows mode.
When installing or uninstalling the OPS positioned at the large
screen's back, ensure that a hard shutdown is performed for
the large screen's power button; otherwise, the OPS may be
abnormal. If the OPS is installed during device power-on,
perform a hard shutdown and power on the OPS again before
using it.
The large screen supports the HarmonyOS and Windows
modes.
• HarmonyOS (default): The OPS is presented as an app
on the large screen. In this mode, you can tap the
Windows icon in the lower left corner of the home page to
access the OPS.
• Windows: The large screen is used as the display to
display the OPS only. To switch to the Windows mode,
choose Settings > Advanced > System > System
Mode in the lower right corner of the home page. In this
mode, you can swipe from the left edge of the screen to
the right to display the setting page. Tap Advanced to
switch back to the HarmonyOS mode.
Method
Note
Peripherals
To Next Page
Loading...
