Figure 5-4 Add Device Step 2-2: Configure Information
4. Enter configurations, including the user name, password, and port of the device. In the
Login Information area, enter the Username, Password, and Port of the device to be
added. The default value of Port is 22.
NOTE
– The default user name and password of the storage system are admin and Admin@storage
respectively.
– Run show system server_port server_name=SSH to check whether the SSH port ID is 22. If
the port ID is not 22, run change system server_port server_name=SSH port_num=22 to
change it to 22.
5. Click Finish.
The newly added device is displayed in the device list.
NOTE
l When a device is added for the first time or a device certificate is not trusted, a message is displayed
indicating that the connection is not trusted.
l When an SSH server is added for the first time or the fingerprint of an SSH server changes, a
message is displayed asking whether you want to continue to register the SSH server.
Step 6 Click OK, go back to the Health Check page, and click Inspection, as shown in Figure 5-5.
OceanStor Dorado V3 Series
Parts Replacement
5 Replacing FRUs
Issue 05 (2019-01-30) Copyright © Huawei Technologies Co., Ltd. 73
To Next Page
Loading...
