Huawei OceanStor Dorado V3 Series - Replacing an Expansion Module

Figure 5-99 Closing the panel
Step 9 Confirm the replacement.
1. Perform a post-replacement inspection.
After the parts replacement, return to the SmartKit page and click Replaced. Then
complete the check after the replacement as prompted.
2. Check system status.
On the Parts Replacement page, click Inspection to check the system status again. If
any inspection item fails, rectify the fault based on the suggestions in the inspection
report.
3. After the preceding procedure is complete, check services on the host for any storage-
related error.
----End
Follow-up Procedure
After the fan module is replaced, label it to facilitate subsequent operations.
5.11 Replacing an Expansion Module
This section describes how to replace an expansion module.
OceanStor Dorado V3 Series
Parts Replacement
5 Replacing FRUs
Issue 05 (2019-01-30) Copyright © Huawei Technologies Co., Ltd. 176