5
Item Description
PAIR Pair/Exit button
Pair:
Used to establish connection between two powerline devices.
Press and hold this button for about 1 second (from 0.5 second
to 4 seconds), and then release it. The PLC indicator will start
to blink. Within 2 minutes, press the PAIR button on the other
powerline device. If PLC indicators on both two powerline
devices turn to steady on from blinking status, it indicates that
connection between the PT530 and the PT500 has been
established successfully.
Exit the paring:
Used to exit the current pairing connection and prepare for a
new connection with other powerline device. Press and hold
this button for more than 8 seconds until the PWR indicator
turns off and then release it. The PT530 will exit the pairing
connection.
To Next Page
Loading...
