Step 9 – Verify services.
4.3
Quickly Configuring Mid-sized
Campus WLANs
Follow the procedure shown below to configure network devices to build a wireless network
for the campus and enable users to access the Internet from anywhere at any time.
58
Step 10 – Save the
configuration.
Step 1 – Set the NAC mode
to unified on the AC.
Step 2 – Configure the AC
so that the AC and APs can
transmit CAPWAP packets.
Step 4 – Configure the AC to
assign IP addresses to APs
and Router to assign IP
addresses to STAs.
Step 5 – Configure a VLAN
pool for service VLANs.
Step 3 – Configure the AC to
communicate with the
upstream network device.
Step 7 – Configure WLAN
service parameters.
Step 8 – Configure channels
and power for AP radios.
Step 6 – Configure APs to
go online.
To Next Page
Loading...
Need help?
General