Huawei SmartLogger3000 Quick Guide

13
6
Powering On the System
1. Connect the power supply.
•
Method 1: When a power adapter is used, connect the power adapter cable and turn on
the switch on the AC socket side.
•
Method 2: When the DC power supply is used, check that the cable between the DC
power supply and the SmartLogger is correctly connected. Turn on the upstream power
switch of the DC power supply.
2. When MBUS is used for communication, turn on all the upstream switches of the MBUS port.
3. Observe the LED indicators to check the running status of the SmartLogger.
•
The rated input voltage of the
power adapter is 100–240 V
AC, and the rated input
frequency is 50/60 Hz.
•
Select an AC socket that
matches the power adapter.
5
Check Before Power-On
No.
Criterion
1
The
SmartLogger is installed correctly and securely.
2
All cables are securely connected.
3
Routing of power cables and signal cables meets the requirements for routing
electric and
ELV cables
and complies with the cable routing plan.
4
Cables are bound neatly, and cable ties are secured evenly and properly in the same
direction.
5
There is no unnecessary adhesive tape or cable tie on cables.

Huawei SmartLogger3000 Specifications

General

Brand	Huawei
Model	SmartLogger3000
Category	Data Loggers
Language	English