5
3
Installing the SUN2000
1. Install the mounting bracket.
•
The M12x40 bolt assemblies are
delivered with the SUN2000. If the bolt
assembly length does not meet the
installation requirements, prepare M12
bolt assemblies by yourself and use
them together with the delivered M12
nuts.
•
Before installing the mounting bracket,
remove the security Torx wrench from
the mounting bracket and save it for
later use.
•
This document introduces how to install
the SUN2000 on a support as an
example. For details about wall-
mounted installation, see the user
manual.
2. Unpack the inverter and move it to the specified position.
Handles are packed in a fitting bag and are not delivered with the SUN2000.
To Next Page
Loading...
