15
1. Remove an appropriate length of the
jacket and insulation layer from the solar
tracker power cable using a wire stripper.
(Ensure that the jacket is in the
maintenance compartment.)
Connection Through the AC Terminal Block
Jacket
Insulation
layer
Core
wire
2. Route the cable through the cable gland.
When installing the solar tracker power cable through the AC terminal block, you need to
prepare OT terminals for the M8 screws.
3. Connect the solar tracker power cable
to the terminal block, and secure the
terminal using a torque wrench with
an extension rod.
When connecting the solar tracker power
cable to the terminal block, ensure that the
crimped OT terminal of the solar tracker
power cable is placed before the crimped
OT terminal of the AC output power cable.
Do not place flammable materials around the cable.
L2=L1+3 mm
L1
≤ 230 mm
To Next Page
Loading...
Need help?
General