Huawei UPS5000-A-H Series - Verifying the Installation

7
The wire routed from the middle point between
positive and negative battery strings is the neutral
wire. Take a battery string consisting of 40 batteries
for example. The battery neutral wire is routed from
the middle between positive and negative battery
strings, each consisting of 20 batteries.
NOTE
Silk Screen Port
Bolt
Specifications
Torque
1L1, 1L2, 1L3, N
Mains input M10x30 35 N·m
2L1, 2L2, 2L3, N
Bypass input M10x30 35 N·m
+, N, -
Battery input M12x45 55 N·m
U, V, W, N
Output M10x30 35 N·m
PE
PE M8x20 12 N·m
4
Verifying the Installation
1. Check that there is no foreign matter at the top
and bottom of the cabinets, copper bars,
switches, and the rear of units.
2. After verifying the installation, reinstall all
the covers.
3. (Remove the paper protective film from the
sealing putty.) After routing cables and
verifying cable connections, seal the gap
between cables and the cabinet using
sealing putty.
4. Do not remove the dustproof cover before power-on to prevent dust inside the UPS.
Sealing putty
Sealing putty must be used as a whole
and the gap can be sealed only from the
top.
Paper
protective film