Measuring SpO2
• To use this feature, update your wearable device and the Huawei Health app to their
latest versions.
• To ensure the accuracy of the SpO2 measurement, wear the wearable device snugly
and in the correct manner. Make sure that the monitoring module is in direct contact
with your skin, free of any obstructions.
1 Wear your wearable device in the correct manner, and keep your arm still.
2 Press the Up button on your wearable device to enter the app list, swipe up or down on
the screen until you see SpO2 (
), and touch this option.
3 For certain products, you'll need to touch Measure. The actual product interface shall
prevail.
4 Remember to keep still with the screen facing upwards, during SpO2 measurements.
Enabling/Disabling Automatic SpO2 measurement
1 Open the Huawei Health app, touch Devices then the name of your connected device,
and enter its details screen. Touch Health monitoring, and enable/disable Automatic
SpO2 measurement.
2 Touch Low SpO2 alert to set the lower limit of your SpO2 for you to receive an alert
when you are not asleep.
Measuring your skin temperature
Skin temperature measurements are mainly used to monitor the changes in the wrist skin
temperature after exercise. After you enable a continuous skin temperature measurement,
your skin temperature will be continuously measured and a measurement curve will be
generated.
• The product is not a medical device. Temperature measurements are mainly used to
monitor the changes in the wrist skin temperature of healthy people over the age of 18
during and after exercise. Results are for reference only and should not be used as a
basis for medical diagnosis or treatment.
• During the measurement, wear the device relatively tightly for more than 10 minutes
and stay in a relaxed environment at room temperature (about 25°C). Ensure that
there are no water stains or alcohol on your wrist. Do not start a measurement in an
environment with direct sunlight, wind, or cold/heat sources.
• After you exercise, shower, or switch between outdoor and indoor environments, wait
30 minutes before you start a measurement.
Health Management
22
To Next Page
Loading...
