Huffy cruiser - Front Wheel Installation; Front Wheel Installation Warning

10
Assembly
Front Wheel Install:
1. If the Axle Nuts
A
are already attached to
the front wheel axle, begin by removing
them with an open end wrench or
adjustable wrench.
2. Set the wheel into the front fork
B
.
3. Install wheel retainers
C
making sure
the tabs are in the fork
D
tab holes.
4. Attach the front wheel with the Axle
Nuts
A
.
5. With the wheel in the center of the
fork and tighten both nuts securely.
WARNING:
• Do NOT use Axle Nuts without serrations to attach the front wheel.
• Ensure wheel spins freely without contacting fork or fender.
• Failure to obey these steps can allow the front wheel to loosen while riding. This can cause
injury to the rider or to others.
B
C
C
A
A
D