Huffy cruiser - Front Fender Installation; Lower Fender Brace Attachment

9
Assembly
Front Fender Installation:
Loosen the Front Brakes (IF EQUIPPED) ( g. 1):
1. Squeeze the two Brake arms together
A
.
2. Lift out the Brake Cable Guide
B
from the Guide
Bracket
C
.
ASSEMBLY  FENDER TABS  g . 2:
NOTE: Some Tabs are Notched for easier assembly. If
Tabs are not notched, remove Bolt, Washer and Nut  rst.
1. Loosen Nut
A
and slide Washer
B
out just far
enough to hook Fender Mount Tabs
C
over Bolt
D
as shown (View. 1).
2. With Fork and Fender facing FORWARD and Fender
Mount Tabs
C
fully over Bolt
D
(View 2), tighten
Nut
A
securely so that both Fender Mount Tabs
do not move.
g 01
C
A
A
B
B
C
A
A
B
D
D
C
C
21
fwd/delantera/avant
If equipped
Si se equipa
Selon l'équipement
g 2
NOTE: Adjust fender up or down as needed for tire clearance.
ATTACH LOWER FENDER BRACES:
NOTE: If pre-installed, remove Bolts from fork.
1. Line up the lower Fender Braces
A
with the Fork
Mounting Tabs
B
.
2. Insert each lower mounting Bolt
C
into the Fork
Mounting Tabs
B
and tighten securely.
H
J
F
G