Huffy Green Machine - Tire and Tube Replacement; Removing Existing Tire and Tube; Installing New Tire and Tube

23
Maintenance
Tire and Tube Replacement
STEP 1 - Remove Existing Tire and Tube:
1 2 3
A
Steps (start opposite Filler Valve):
1. Insert a Tire Lever under Tire Bead (A).
2. Hook end of Tire Lever on a spoke.
3. Insert second Tire Lever and slide along rim to remove tire bead.
4. Remove Inner Tube and Tire.
5. Inspect for cause of at and remove any foreign object from the tire if necessary.
1. Using your hands, start with one Bead (A) of Tire (B) and install it all the way
around Rim (C).
2. Insert a slightly inated Inner Tube (D) into
the Tire and make sure the Valve Stem (E) is
straight and aligned with the Rim Hole.
3. Work the second Tire Bead onto the Rim all
the way around. This will take a little more
effort than the rst Tire Bead did. Use Tire
Lever Tools if needed.
4. Make sure the Tube does not get pinched
between Rim and Tire.
5. Inate Tire just enough that it takes shape.
6. Double check that both Tire Beads are seated
properly and that the Valve Stem is pointing
straight out.
7. Fully inate tube to recommended pressure
listed on Tire side wall - do not over-inate.
8. Install Valve Cap.
STEP 2 - Installing New Tire and Tube:
D
A
B
C
E