Huffy Green Machine - Installing Rear Wheels; Rear Wheel Mounting

18
Installing Rear Wheels
A
F
G
G
F
B
CD
2
1
E
D
Assembly
STEPS:
NOTE: Axle may be Bolt style or Threaded Rod style (D). Threaded Rod style will
have a Washer (F) and Lock Nut (G) on both ends. Bolt Style will have a larger
Washer (C) under the head of the Bolt.
1. Insert a Bushing (B) in both Wheel Axle Holes. Ensure Bushing is fully seated
in the wheel. (Bushings may be pre-installed)
2. Position Wheel (A) with inset graphic facing outwards.
3. If Threaded Axle Rod style (1): Place a Washer (F) and Lock Nut (G) on one
end of Axle Rod (D). Insert Axle Rod through Frame (E).
4. If Bolt style (2): Place larger Washer (C) onto Axle Bolt (D) and insert Axle Bolt
through Frame (E).
5. Place Wheel/Bushing assembly over end of Axle (D) making sure Bushings (B)
do not come loose.
6. Install Washer (F) and Lock Nut (G) onto Axle.
7. Tighten Lock Nut(s) securely. See Torque Chart for recommended torque.
8. Repeat steps for opposite side wheel.
WARNING:
• Ensure Axle Bolt Threads are fully through the Lock Nuts.
• Ensure Wheels spin freely and evenly and are not loose side to side.