Hunter 23902 - Activating Perfect Balance System; Downrod Length Consideration

11
42776-01•04/29/08•HunterFanCompany
Steps 7-1 – 7-2
7-1. If you are using one of the enclosed downrods, it is now time
for you to activate the Perfect Balance
TM
system by removing the
veredretainingscrews.Rotatethebladesslowlyuntiloneofthe
red retaining screws is visible through the notch in the mounting
plate.Removetheretainingscrewfromthebottomofthefan
housingusingascrewdriver.Repeatthisprocessforall5retaining
screws.
Note: Aftertheretainingscrewsareremoved,thebladeswillfeelloose.
is is normal, as loose blades are a characteristic of the Perfect
Balance
TM
system.
7-2. If you are using a downrod longer than 6 inches, leave the
retaining screws in their place and continue the installation
process.
Notch
SwitchHousing
Mounting Plate
RedRetaining
Screws
7 • Activating Perfect Balance
TM