Hunter 23902 - Assembling and Hanging the Fan; Standard Mounting Assembly

6
42776-01•04/29/08•HunterFanCompany
Steps 3-2 – 3-3
Downrod
Canopy
TrimRing
Note: YourHunterfancomeswithanoptionaldownrodextension
pipe. If you are hanging the fan on a ceiling higher than 10 feet tall
and you would like to use the enclosed optional downrod, follow
steps 3-5 –3-9onthenextpage.
3-1. Unbundlethewiresfromthefan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
For Standard or Angled mounting:
3-2. Insert the downrod through the canopy and canopy trim ring.
Feed the wires from the fan through the downrod.
3-3.UsingtheprovidedAllenwrench,loosenthesetscrewonthe
adapter to install the pipe and ball assembly. Note: When the
pipe and ball assembly is fully installed, 2-3 threads on the pipe
willstillbevisible;thisisnormal.UsetheAllenwrenchtosecurely
retighten the setscrew.
CAUTION: e adapter has a special coating on the threads. Do
notremovethiscoating;thecoatingpreventsthedownrodfrom
unscrewing.Onceassembled,donotremovethedownrod.
3-4.Raisethefanandplacethehookontheceilingplatethroughthe
U-shapedholeintherim.
Setscrew
Canopy
3 • Assembling and Hanging the Fan
AllenWrench
U-shaped
Hole
Step 3-4