Hunter 44008-01 - Page 24

24
Step 4 ■ Press again to change to the program temperature. The cur-
rent temperature will be ashing.
■ Press to change the temperature.
Step 5 ■ Press to select Auto or On for each program. “Auto” will auto-
matically cycle your system to maintain your set temperature.
“On” will run your system continuously. “Auto” is the default
setting.
Step 6 ■ (Does not apply to thermostat model 44660) Press to select
the sensor that will control each thermostat program, either
for sensor 1, for sensor 2, or for the thermostat.
The thermostat can also be congured to take an average of
any combination of the three.
Step 7 ■ Press again to move to the next program number.
■ Repeat Steps 3 through 5 to change the remaining Weekday
programs.
or
program
program
fan
sensor
1
2