© 2001 Hunter Fan Company 3 41521-01 9-4-2001
Troubleshooting
Symptom Possible Causes Solution
1. No functions operate.
2. Operates only at close range.
3. Inconsistent operation.
Main Power not restored. Replace fuse. Turn ON circuit breaker. Turn
ON wall switch.
Fan pull chain not set to HIGH. Turn OFF power at wall switch or main
electric panel. Set fan to HIGH speed.
Light pull chain not set to ON. Set light kit to ON.
Receiver wiring incorrect. Verify wiring connections.
Transmitter and receiver jumper switches do
not match.
Set transmitter and receiver to same jumper
switch setting.
Battery too weak. Replace with new, alkaline battery.
Signal blocked from reaching receiver. Extend antenna into ceiling box, or move it
for better reception.
Battery too weak. Replace with new, alkaline battery.
Signal partially blocked from reaching receiver. Extend antenna into ceiling box, or move it
for better reception.
RF interference. Turn OFF wall switch for 5 seconds, then
turn back ON.
Continuing RF interference. Change dip switch settings to a different
code in both Transmitter and Receiver.
To Next Page
Loading...
